Air Tub Remote Instructions

  1. How To Sync Your Air Tub Remote 

To sync your air tub remote, have the remote in hand with clear access to the sensor. If the receiver module is not in plain view from the tub’s location, your remote control will not function properly. 

To program the remote, press and hold the second and third buttons simultaneously for 4 seconds. The remote control should synchronize and be ready for use. However, if programming is unsuccessful, you can perform a reset by unplugging the blower motor from the wall and plugging it in again. From this moment, you have 15 seconds to proceed with another attempt to program. 

 

  1. How To Control Your Jetted Air Tub 

With your air tub, you will also receive a remote that is integral to obtaining the best experience. Looking at the remote, you will notice that it has four buttons—each controlling different settings and preferences: 

• Use the top button to turn the air bath on and off. 

• Increase or decrease the frequency of the bubbles with the plus and minus buttons. Please note that these buttons will not influence the pressure of the jets, but rather their speed. 
• Use the remaining button to control the pulse, or vibration, of the air bubbles. 

Was this article helpful?
7 out of 22 found this helpful